BRP can-am MAVERICK MAX X MR 2023 Operator's Manual page 136

MAINTENANCE PROCEDURES
T T i i g g h h t t e e n n i i n n g g T T o o r r q q u u e e
Beadlock
screws
(SECOND
TORQUE)
T T Y Y P P I I C C A A L L - - T T I I G G H H T T E E N N I I N N G G S S E E Q Q U U E E N N C C E E
N N O O T T E E : :
The beadlock clamp ring should be in
contact with the beadlock inner ring.
The beadlock clamp ring can flex
slightly to match the tire bead. IT IS
NORMAL.
6. Verify the gap between tire and
beadlock clamp ring, it should be
practically equal all around the
ring.
1. Tire
2. Beadlock clamp ring edge
1. Gap equal all around beadlock clamp ring
If the gap is not acceptable,
– Loosen all screws.
134
25 ± 1 Nm
(18 ± 1 lbf-ft)
– Check tire position on wheel
and reposition it if necessary.
– Restart the torquing sequence
as detailed.
7. Torque beadlock screws a f f i i n n a a l l
time following
sequence.
T T i i g g h h t t e e n n i i n n g g T T o o r r q q u u e e
Beadlock
screws (FINAL
TORQUE)
T T Y Y P P I I C C A A L L - -
S S E E Q Q U U E E N N C C E E
8. Inflate tire to seat the inner bead
on wheel. Always use safe practi-
ces, such as a tire safety cage.
W W A A R R N N I I N N G G
N N e e v v e e r r e e x x c c e e e e d d t t i i r r e e ' ' s s r r e e c c o o m m m m e e n n d d e e d d
m m a a x x i i m m u u m m p p r r e e s s s s u u r r e e f f o o r r s s e e a a t t i i n n g g
b b e e a a d d s s . .
S S u u s s p p e e n n s s i i o o n n s s
F F r r o o n n t t S S u u s s p p e e n n s s i i o o n n L L u u b b r r i i c c a a t t i i o o n n
Lubricate upper and lower suspension
arms.
XPS synthetic suspension grease
There are 2 grease fittings on each
suspension arm.
the indicated
25 ± 1 Nm
(18 ± 1 lbf-ft)
F F I I N N A A L L T T I I G G H H T T E E N N I I N N G G