BRP can-am MAVERICK MAX X MR 2023 Operator's Manual page 96

L L I I F F T T I I N N G G A A N N D D S S U U P P P P O O R R T T I I N N G G T T H H E E V V E E H H I I C C L L E E
F F r r o o n n t t o o f f V V e e h h i i c c l l e e
Place vehicle on a flat non slippery
ground.
Engage the 4WD mode.
Ensure vehicle shift lever is set to
PARK.
Install an hydraulic jack under the
round tube.
F F R R O O N N T T O O F F V V E E H H I I C C L L E E
1. Hydraulic jack position
Lift front of vehicle and install a jack
stand on each side under frame as
shown below:
J J A A C C K K S S T T A A N N D D P P O O S S I I T T I I O O N N S S - - F F R R O O N N T T O O F F
V V E E H H I I C C L L E E
Lower hydraulic lift and ensure vehicle
is supported safely onto both jack
stands.
94
R R e e a a r r o o f f V V e e h h i i c c l l e e
Place vehicle on a flat non slippery
ground.
Activate 4WD mode.
Ensure vehicle shift lever is set to
PARK.
Install an hydraulic jack under the
vehicle.
R R E E A A R R O O F F V V E E H H I I C C L L E E
1. Hydraulic jack position
Lift rear of vehicle and install a jack
stand on each side under frame as
shown below:
J J A A C C K K S S T T A A N N D D P P O O S S I I T T I I O O N N S S - - R R E E A A R R O O F F
V V E E H H I I C C L L E E
Lower hydraulic lift and ensure vehicle
is supported safely onto both jack
stands.