BRP can-am MAVERICK MAX X MR 2023 Operator's Manual page 127

T T i i g g h h t t e e n n i i n n g g T T o o r r q q u u e e
Ignition coil
retaining screw
Reinstall all other removed parts using
the reverse of removal procedure.
N N O O T T E E : :
Make sure to reconnect the inter-
cooler fan connector (if equipped).
T T i i g g h h t t e e n n i i n n g g T T o o r r q q u u e e
Protective plate
retaining
screws (models
without
intercooler)
Intercooler
retaining
screws (if
equipped)
C C V V T T C C o o v v e e r r
For a better understanding, some il-
lustrations are taken with engine out
of vehicle. To perform the following in-
structions, it is not necessary to re-
move engine.
W W A A R R N N I I N N G G
N N e e v v e e r r t t o o u u c c h h C C V V T T w w h h i i l l e e e e n n g g i i n n e e i i s s
r r u u n n n n i i n n g g . .
N N e e v v e e r r d d r r i i v v e e v v e e h h i i c c l l e e w w h h e e n n C C V V T T
c c o o v v e e r r i i s s r r e e m m o o v v e e d d . .
C C A A U U T T I I O O N N
E E n n g g i i n n e e m m u u s s t t b b e e c c o o o o l l b b e e f f o o r r e e c c o o v v e e r r
i i s s r r e e m m o o v v e e d d . .
N N O O T T I I C C E E
T T h h i i s s C C V V T T i i s s l l u u b b r r i i c c a a t t i i o o n n f f r r e e e e . .
N N e e v v e e r r l l u u b b r r i i c c a a t t e e a a n n y y c c o o m m p p o o n n e e n n t t s s
e e x x c c e e p p t t d d r r i i v v e e p p u u l l l l e e y y b b e e a a r r i i n n g g . .
9 ± 1 Nm
(80 ± 9 lbf-in)
8 ± 1 Nm
(71 ± 9 lbf-in)
MAINTENANCE PROCEDURES
C C V V T T C C o o v v e e r r A A c c c c e e s s s s
CVT cover can be accessed from the
LH side at the rear of vehicle.
P P A A R R T T S S R R E E M M O O V V E E D D F F O O R R C C L L A A R R I I T T Y Y
C C V V T T C C o o v v e e r r R R e e m m o o v v a a l l
N N O O T T E E : : The following procedure is
the same for Turbo engines and Turbo
RR engines.
Loosen CVT inlet hose clamp(s).
1. Clamp
Remove all CVT cover retaining
screws.
Remove the center top screw last to
support the cover during removal.
N N O O T T E E : :
Do not use an impact tool to remove
CVT cover screws.
Remove the CVT cover and its
gasket.
125