MAINTENANCE PROCEDURES
T T i i g g h h t t e e n n i i n n g g T T o o r r q q u u e e
Transverse
arm nuts
B B r r a a k k e e s s
B B r r a a k k e e F F l l u u i i d d R R e e s s e e r r v v o o i i r r L L e e v v e e l l
V V e e r r i i f f i i c c a a t t i i o o n n
Remove the front service cover.
1. Front service cover
1. MIN
2. MAX
3. Master cylinder reservoirs
With vehicle on a level surface, check
brake fluid in reservoirs for proper lev-
el. Brake fluid level should be between
MIN and MAX. marks.
N N O O T T E E : :
A low level may indicate leaks or worn
brake pads.
A A d d d d i i n n g g B B r r a a k k e e F F l l u u i i d d
Clean filler cap before removing.
Add fluid as required. D D o o n n o o t t o o v v e e r r f f i i l l l l . .
136
95 ± 5 Nm
(70 ± 4 lbf-ft)
N N O O T T E E : :
Ensure filler cap diaphragm is pushed
inside the cap before closing the
brake fluid reservoir.
R R e e c c o o m m m m e e n n d d e e d d B B r r a a k k e e F F l l u u i i d d
Always use brake fluid meeting the
specification DOT 4 only.
N N O O T T I I C C E E
T T o o a a v v o o i i d d s s e e r r i i o o u u s s d d a a m m a a g g e e t t o o t t h h e e
b b r r a a k k i i n n g g s s y y s s t t e e m m , , d d o o n n o o t t u u s s e e f f l l u u i i d d s s
o o t t h h e e r r t t h h a a n n t t h h e e r r e e c c o o m m m m e e n n d d e e d d o o n n e e , ,
n n o o r r m m i i x x d d i i f f f f e e r r e e n n t t f f l l u u i i d d s s f f o o r r t t o o p p p p i i n n g g
u u p p . .
D D o o n n o o t t u u s s e e b b r r a a k k e e f f l l u u i i d d t t a a k k e e n n f f r r o o m m
o o l l d d o o r r a a l l r r e e a a d d y y o o p p e e n n e e d d c c o o n n t t a a i i n n e e r r s s . .
B B r r a a k k e e I I n n s s p p e e c c t t i i o o n n
The brake inspection, maintenance
and repair should be performed by an
authorized Can-Am dealer, a repair
shop or person of your choosing.
However, verify the following between
visits to your dealer:
– Brake fluid level
– Brake system for fluid leaks
– Brake pad wear
– Brake cleanliness
W W A A R R N N I I N N G G
T T h h e e b b r r a a k k e e f f l l u u i i d d r r e e p p l l a a c c e e m m e e n n t t o o r r
b b r r a a k k e e s s y y s s t t e e m m m m a a i i n n t t e e n n a a n n c c e e a a n n d d
r r e e p p a a i i r r s s s s h h o o u u l l d d b b e e p p e e r r f f o o r r m m e e d d b b y y a a n n
a a u u t t h h o o r r i i z z e e d d C C a a n n - - A A m m d d e e a a l l e e r r . .
S S e e a a t t B B e e l l t t s s
S S e e a a t t B B e e l l t t C C l l e e a a n n i i n n g g
To clean dirt and debris from the seat
belts, sponge the straps with mild
soap and water. Do not use bleach,
dye, or household detergents.