1. F F l l o o o o d d e e d d e e n n g g i i n n e e ( ( s s p p a a r r k k p p l l u u g g w w e e t t w w h h e e n n r r e e m m o o v v e e d d ) ) . .

– (If the engine does not start and it is fuel-flooded, the drowned mode

can be activated to prevent fuel injection and to cut ignition while

cranking. Proceed as follows:

• Install key on D.E.S.S. post.

• Press completely and HOLD accelerator pedal.

• Press the engine START button.

The engine should be cranked for 10 seconds. Release engine START

button.

Release accelerator pedal and start/crank engine again to allow

starting.

I I f f i i t t d d o o e e s s n n o o t t w w o o r r k k : :

• Remove the spark plugs (tools are supplied in tool kit). Refer to Spark

Plugs in Maintenance Procedures.

• Crank engine several times.

• Install new spark plugs if possible or clean and dry spark plugs.

• If engine does not start, seek service from an authorized Can-Am

dealer, repair shop, or person of your own choosing for maintenance,

repair, or replacement. Please refer to the US EPA Emission-Related

Warranty contained herein for information about warranty claims.

2. N N o o f f u u e e l l t t o o t t h h e e e e n n g g i i n n e e ( ( s s p p a a r r k k p p l l u u g g d d r r y y w w h h e e n n r r e e m m o o v v e e d d ) ) . .

– Check fuel tank level.

– Check fuel pump fuse.

– Obstructed fuel pump pre-filter or fuel pump failure. Seek service from

an authorized Can-Am dealer, repair shop, or person of your own

choosing for maintenance, repair, or replacement. Please refer to the

US EPA Emission-Related Warranty contained herein for information

about warranty claims.

3. S S p p a a r r k k p p l l u u g g / / i i g g n n i i t t i i o o n n ( ( n n o o s s p p a a r r k k ) ) . .

– Check ignition fuse.

– Remove spark plug then reconnect to ignition coil.

– Start engine with spark plug grounded to the engine away from spark

plug hole. If no spark appears, replace spark plug.