BRP can-am MAVERICK MAX X MR 2023 Operator's Manual page 166

M M E E S S S S A A G G E E S S I I N N M M U U L L T T I I F F U U N N C C T T I I O O N N G G A A U U G G E E
If an abnormal engine condition occurs, the following messages can be com-
bined with a pilot lamp.
Message
D.E.S.S. KEY
NOT
RECOGNIZED
BAD KEY
CHECK ENGINE
LIMP HOME
TPS FAULT
BRAKE SWITCH
FAULT
CHECK DPS
PPS FAULT
MANUAL LIMP
HOME
FUEL SENSOR
FAULT
CHECK
SMART-LOK
BELT
OVERHEAT
164
D.E.S.S. key requires cleaning.
Indicates that you have used the wrong D.E.S.S. key, use
the proper key for this vehicle.
All active or previously activated faults that require
attention.
No engine limitation engaged.
Critical faults requiring diagnostic as soon as possible.
An engine limitation is engaged and/or the engine behavior
is modified.
Throttle body fault, generally followed by a Limp Home
message.
Brake signal fault.
Check engine pilot light on. Indicates that the DPS
(Dynamic Power Steering) does not work properly. See an
authorized Can-Am dealer.
Faulty Pedal Position Sensor(s) (PPS). Refer to Override
Switch in Secondary Controls to drive the vehicle in the
limp home mode.
Confirms the Manual Limp Home is engaged using the
Override Switch in case of a PPS fault.
When the fuel sender resistor value is out of range the
multifunction gauge (analog/digital) will detect it and display
the message.
Check engine pilot light on. Indicates that the Smart-Lok
does not work properly. See an authorized Can-Am dealer.
Indicate that the electronic drive belt protection is activated.
The temperature in the vicinity of the drive belt is too high.
Move the shift lever in LOW position and reduce the speed.
Description