BRP can-am MAVERICK MAX X MR 2023 Operator's Manual page 126

MAINTENANCE PROCEDURES
Move intercooler assembly aside
R R e e m m o o v v i i n n g g t t h h e e S S p p a a r r k k P P l l u u g g
1. Disconnect CAPS (camshaft posi-
tion sensor).
2. Remove:
– Ignition coil retaining screws
– Ground connector.
3. Disconnect
connectors.
1. Retaining screws
2. Ground connectors
3. Ignition coil connectors
N N O O T T I I C C E E
D D o o n n o o t t p p r r y y o o n n i i g g n n i i t t i i o o n n c c o o i i l l w w i i t t h h a a
t t o o o o l l . .
4. Remove ignition coils with gaskets
from spark plug by rotating coil
side to side as you pull up.
5. Clean spark plug and cylinder
head with pressurized air.
124
ignition coil
C C A A U U T T I I O O N N
A A l l w w a a y y s s w w e e a a r r s s a a f f e e t t y y g g o o g g g g l l e e s s w w h h e e n n
u u s s i i n n g g p p r r e e s s s s u u r r i i z z e e d d a a i i r r . .
6. Unscrew the spark plugs com-
pletely using a spark plug socket.
7. Use ignition coil as a puller.
I I n n s s t t a a l l l l i i n n g g t t h h e e S S p p a a r r k k P P l l u u g g
Prior to installation make sure that
contact surface of cylinder head and
spark plug is free of grime.
Using a feeler gauge, set the spark
plug gap.
S S p p a a r r k k P P l l u u g g G G a a p p
0.7 to 0.8 mm
(.028 to .031 in)
Screw spark plug into cylinder heads
by hand and tighten to specification
using a torque wrench.
C C A A U U T T I I O O N N
D D o o n n o o t t o o v v e e r r t t i i g g h h t t e e n n s s p p a a r r k k p p l l u u g g s s , ,
e e n n g g i i n n e e d d a a m m a a g g e e c c a a n n o o c c c c u u r r . .
T T i i g g h h t t e e n n i i n n g g T T o o r r q q u u e e
Spark plug
Install the ignition coil on the spark
plug.
Align the retaining screw hole of the
ignition coil with the threaded hole on
the valve cover.
Push the ignition coil all the way down
until it rests on the valve cover.
Install and tighten retaining screw.
11 Nm
(97 lbf-in)