BRP can-am MAVERICK MAX X MR 2023 Operator's Manual page 80

7.6" DIGITAL DISPLAY (KEYPAD)
S S e e t t t t i i n n g g s s
S S e e t t u u p p
Using MENU button on the keypad,
select S S E E T T T T I I N N G G S S and hold to enter
setting menu.
OK button can be pressed instead of
holding MENU button.
5 5 B B U U T T T T O O N N S S K K E E Y Y P P A A D D
1. DRIVE MODE button
2. MENU button
3. OK button
4. TRIP button
5. DPS button
M M a a i i n n t t e e n n a a n n c c e e R R e e s s e e t t
N N O O T T E E : :
Only when the maintenance icon is
displayed.
Using MENU button, select R R E E S S
M M A A I I N N T T and
maintenance.
F F a a u u l l t t C C o o d d e e s s
Available only when at least one code
is activated.
Using MENU button, select C C O O D D E E S S
and hold to see active fault codes.
Fault codes will be scrolled on the
Lower Display.
R R e e s s e e t t S S t t a a t t s s
Using MENU button, select R R E E S S E E T T
S S T T A A T T and hold to reset.
78
hold to reset
U U n n i i t t S S e e l l e e c c t t i i o o n n
This multifunction gauge is factory
preset in Imperial units but it is possi-
ble to change it to Metric units.
Using MENU button, select U U N N I I T T S S
and hold button to change units.
S S p p e e e e d d / / R R P P M M
The speed and RPM display can be
swapped.
Using MENU button, select S S P P E E E E D D / /
R R P P M M and hold button to invert speed
and RPM display.
S S e e t t t t i i n n g g C C l l o o c c k k
All of the following action must be per-
formed using the MENU button.
1. Select C C L L O O C C K K and hold to change
time.
2. Press the button to select clock
display.
3. Push and hold the button for 1
second.
4. Press the button to select 12:00
AM PM or 24:00 time base.
5. Push and hold the button or OK
button to acknowledge selection.
6. Press the button to change hours
(hours flash).
7. Push and hold the button or OK
button to
selection
8. Push the button to switch to mi-
nutes (minutes flash).
9. Push and hold the button to ac-
knowledge minutes selection.
S S e e t t t t i i n n g g B B r r i i g g h h t t n n e e s s s s
The brightness of the LCD display can
be adjusted.
Using MENU button, select B B R R I I G G H H T T - -
N N E E S S S S and hold MENU button to se-
lect the brightness setting.
Using MENU button, adjust brightness
then push and hold MENU button to
acknowledge selection.
acknowledge hour