Thermo Scientific Barnstead Pacific TII 7 Operating Instructions Manual page 49

Step Action
2 Stick the universal adapter to a smooth wall surface or
screw it to the wall (screws are not provided).
3 a.) Take the power supply unit and press it with the
attached universal holder onto the wall and then slide it
down (see red arrows).
b.) Plug the power cable into the power supply unit.
Do not bring the power pack in contact with water. Risk of
an electrical shock..
The removable power cable must always face downward
when the power supply unit has been mounted.
5 Now, connect the power supply unit to the 'Power supply'
connection on the right side of the Pacific Water
Purification. Next plug the power supply to a grounded
100 - 240V, 50-60 Hz power outlet.
Make sure that the power supply connector is always free
accessible. (see Chapter 5
and pure water tanks"
Thermo Scientific
"Accessibility to Pacific systems
on page 16)
Figure
Universal adapter
a.)
Power supply unit
with support
b.)
Mains adapter
Power supply
connection on
the system
Pacific Water Purification Systems
7
Installation
Wall surface
Universal adapter
Power cable
39