3. Press the ENTER soft key to save the change or the ESCAPE soft key to cancel the
change.
4. Press the BACK soft key to return to the Settings menu.
Filtering
This setting is used to adjust the transition of signals on the flow meters. The filter has
four levels: Soft, Medium, Hard, and None.
When filtering is on, full test parameters are invalid.
To change the filtering level:
1. Highlight Filtering.
2. Press the MODIFY soft key to toggle to the desired value.
3. Press the ENTER soft key to save the change or the ESCAPE soft key to cancel the
change.
4. Press the BACK soft key to return to the Settings menu.
Display Calibration Date on Startup Screen
Use this option to control whether the calibration due date appears on the startup screen.
To select whether the calibration due date is shown on the startup screen:
1. Highlight Display Cal Date.
2. Press the MODIFY soft key to toggle between YES and NO.
3. Press the ENTER soft key to save the change or the ESCAPE soft key to cancel the
change.
4. Press the BACK soft key to return to the Settings menu.
Serial Mode
Use this option to control what data is available through the Analyzer serial port. The
possible options are shown in Table 2-3.
Option
Comp Ctrl
RT200
None
Note
Table 2-3. Serial Port Options
Computer Control – specialized serial communications used by the VT for
Windows PC Software; contact your sales representative for the protocol if
needed.
A serial mode that emulates the Allied RT200 serial communications
No serial communications
Connection and Setup
Setting Analyzer Operating Parameters
Description
2
2-15