Printer Cable Attachment - Fluke VT Plus HF Operator's Manual

VT Plus HF
Operators Manual
3. Ensure that the breath detection mode is set to Unidirectional Expiratory.
The Analyzer displays a screen showing the flow of gas delivered by the ventilator:
The instantaneous flow rate displays in large numbers in the upper right portion of the
screen. The flow statistics (min., max and average) are shown below in the center right
portion of the screen. A subset of the breath parameters is shown below the flow plot.
The following adjustments can be made to the screen:
•
•
•
•
•
•

Printer Cable Attachment

The printer uses a D25 male to Centronics parallel cable for parallel printing. This cable
is available from Fluke (part #2238072) or from most electronic supply outlets.
To attach the parallel cable:
1. Connect the 36-pin end for the Centronics type parallel cable to the printer's parallel
2. Attach the 25-pin male end of the parallel cable to the 25-pin connector on the back
2-6
a. Go into Setup
b. Choose Settings
c. Choose Breath Detect and modify as needed
Switch between the high- and low-flow ports – Press the RANGE soft key.
Change the measurement units (LPM, CFM, LPS) – Press the UNITS soft key.
Change the plot scaling – Press the RESCALE soft key. The new scaling is based on
the minimum and maximum values shown in the statistics area.
Erase the plot and re-initialize the statistics and breath parameters – Press the
CLEAR soft key.
See more information in any screen – Press the HELP key.
Pause and resume the plot screen, respectfully – Press the PAUSE/RESUME key.
input connector.
of the Analyzer.
fec049.bmp