Table of Contents
Advertisement
Option
File
This menu gives access to the file handling, and printing functions of this
software. For a complete description see the Data and File Handling section in
this chapter.
Communications
The communications menu allows selection of the communications port and the
serial data mode. For a complete description see the Serial Communications
section in this chapter.
Plots
The plot menu provides access to the plot re-scaling functions. It allows
changing of the plot on any of the monitors, and turn on or off the automatic re-
scaling. For a complete description see the Plots section in this chapter.
Statistics
The statistics menu gives access to the clear function for any or all statistics.
The CLEAR ALL function clears the statistics for all of the signals at once, to
clear individual signals select the option with its name.
Zero
The zeroing menu allows manual zeroing any or all of the signals. The ZERO
ALL function zeros all of the signals except oxygen. To zero any of the
individual signals, select its name from the ZERO menu. Airway pressure and
flow are always zeroed at the same time.
Setup
The setup menu provides access to most of the user setup features found in
the Analyzer.
Option
Flow Port
Use this menu to select which flow port to use. The checked option is the
currently selected flow port.
Zeroing
The Zeroing menu is used to select a zeroing mode, either automatic or
manual. The current zeroing mode is checked. See the Zeroing section later in
this chapter.
Breath Detect
Use the breath-detect menu to switch breath detection modes, and to set the
breath detect threshold for the current flow port.
Gas Settings
The gas settings function brings up the GAS SETTINGS dialog box. See the
Gas Settings section later in this chapter.
Barometric Pressure
This function brings up the barometric pressure dialog box. Enter the local
barometric pressure in mmHg and click OK to calibrate the barometric pressure
sensor.
Signal Units
The signal units function brings up a dialog box for entering the desired units for
the signals. See Signal Selection under the Plots section of this chapter.
Print Header
The print header function sets the print header in the Analyzer. See the Printing
section in this chapter.
Help
Accesses the VT for Windows help file
Table 4-2. Menu Bar Options
Description
Table 4-3. Setup Submenu Options
Description
Remote Operation
4
Menu Bar
4-7
Advertisement
Table of Contents
