Table of Contents
Advertisement
Installation examples
This section gives examples of how to place the drive and additional equipment into
a Rittal VX25 enclosure.
Each example includes a table that lists:
•
installation stages of different equipment in the order in which the installation
into the enclosure should be done
•
instruction code of the step-by-step instructions
•
equipment kit code
•
kit ordering code.
You can find the kit-specific assembly drawings, step-by-step instructions and kit
information on the Internet. Go to
https://sites-apps.abb.com/sites/lvacdrivesengineeringsupport/content. If needed,
contact your local ABB representative.
The example includes also cabinet assembly drawings that show each stage listed in
the table. More detailed steps of each stage are described in the kit-specific assembly
drawings. The tightening torques are listed in the kit-specific assembly drawings. See
the hardware manual for the tightening torques of drive module input and output
terminals.
For general instructions, see
instructions (3AUA0000107668
WARNING!
Remove the code labels attached to mechanical parts such as busbars,
shrouds and sheet metal parts before installation. They may cause bad
electrical connections, or, after peeling off and collecting dust in time,
cause arcing or block the cooling air flow.
WARNING!
To avoid breaking the coolant pipes, do not overtighten the nuts of the unions.
Leave 2...3 mm (0.08 ... 0.12") of thread visible.
2...3 mm (0.08 ... 0.12")
Drive modules cabinet design and construction
[English]).
Cabinet construction 43
10
Advertisement
Table of Contents
