Openvpn® Settings - Grandstream Networks WP820 Administration Manual

Goo
d
Sign
al
Sets the time interval for signal scanning when the Wi-Fi signal strength is higher than the signal threshold. Default
Scan
is 600s, and valid range is from 5 to 600.
ning
Inter
val
(s)
Poor
Sign
al
Sets the time interval for signal scanning when the Wi-Fi signal strength is lower than the signal threshold and there
Scan
ning is no hotspot that is higher than the current signal strength. Default is 5s, and valid range is from 5 to 600.
Inter
val
(s)
OpenVPN® Settings
Enable OpenVPN®
OpenVPN® Mode
Enable OpenVPN® Comp-lzo
OpenVPN® Server
OpenVPN® Port
OpenVPN® Transport
OpenVPN® CA
Table 24: Wi-Fi Settings
Enables/disables OpenVPN® functionality and requires the
user to have access to an OpenVPN® server.
Note: To use OpenVPN® functionalities, users must enable
OpenVPN® and configure all of the settings related to
OpenVPN®, including server address, port, OpenVPN® CA,
certificate, and key. Additionally, the user must also set the
SIP account to use "VPN" for the "NAT Traversal" (under
Account à Network Settings).
Simple mode only supports some basic or common
parameters configuration; Professional mode supports
configuration file upload in zipped format, which is totally
customized by need, please refer to https://openvpn.net for
more information.
Enables/disables the LZO compression. When LZO
compression is enabled on the OpenVPN server, this option
needs to be checked otherwise there will be a network
connection failure. The P-value for this functionality is
P8508 with two possible values 0 and 1; 0 – OFF/1 - ON.
Default setting is NO.
Defines the URL/IP address for the OpenVPN® server.
Defines the network port for the OpenVPN® server. The
default setting is 1194.
Determines network protocol used for OpenVPN® (UDP or
TCP).
The default setting is TCP.
OpenVPN® CA file (ca.crt) required by the OpenVPN® server
for authentication purposes. Press "Upload" to upload the
corresponding file to the device.