Dhcp Server; Pbxware Version; Installation; Basic Setup - Grandstream Networks HT-802 Manual

note that the default username is admin and the default password is admin.

DHCP Server

Fully configured and operational DHCP server.

PBXware Version

PBXware version 5.3.6
In order to find out the PBXware version:
Log in to PBXware.
Navigate to Settings: About.
On the top of About page, you may see a code similar to this one PBXware Edition: Business,
Release: 5.3.6. (387597b7), Running: 1.8.32.1-gc-b47edc45, PBXware Proxy v5.3.6
(62b7bcd), API: 5.3, libmemcached version: 1.0.14, where Release denotes the current
version of your PBXware.

Installation

This section describes how to install and set up your Grandstream HT-802 for Manual
configuration or Auto provisioning with PBXware.

Basic Setup

Connect the DC plug on the power adapter to the DC port on the device and connect the other
end of the power adapter into an electrical power outlet.
Connect the ethernet cable between the Internet port on the device and the network port on a
router or switch to access LAN.
Connect the analog phone to the Phone 1 port.
NOTE:
The Grandstream HT-802 device has four analog phone ports, so if needed, four phones
can be registered by using a single ATA device.
After you connected the analog phone to your HT-802 device, pick up the phone and dial:
*** - enter the configuration menu
02 - the IP address announcement
Write down the IP address for your future reference. When the procedure above is completed,
you should be able to reach the ATA web interface by entering the announced IP address into
your browser's address bar.

Reset to Factory Settings

This step is not required for brand new out-of-the-box devices, however, if the device has been
already used then it is a must.
Open a new browser window and enter your device's IP address in order to access the web