Find The Phone's Ip Address; Reset To Factory Settings; Registering Phone; Manual Configuration - Grandstream Networks GXV3350 Configuration Manual

the in-line power router or switch.
NOTE: If you are using Power over Ethernet (PoE), you don't need to connect the AC adapter.
Make sure that the Ethernet cable and router or switch is Power over Ethernet (PoE) compliant.

Find the Phone's IP Address

Find out your Grandstream phone's IP Address.
Go to Settings.
Scroll down to Status.
Go to Network status and the IP address should be shown under the IPv4 address field.

Reset to Factory Settings

This step is not required for brand new out-of-the-box phones, however, if the phone has been
already used then it is a must.
Open a new browser window and enter your phone's IP address in order to access the phone's
web administration interface login screen. Example: http://192.168.1.22.
Log in to the phone's web administration interface with your username and password. Please
note that the factory default login details are as follows: username is admin and password is
given at the back of the phone.
Click Maintenance in the left hand navigation menu.
Click Upgrade in the left hand navigation menu.
Click Advanced Settings at the top navigation menu.
Click the Reset button and confirm with OK on prompt. A phone will reset to the factory
settings and reboot.
Wait some time for a device to reboot.
NOTE: Do not unplug or remove power from the phone while it is updating firmware and
configuration.

Registering Phone

This section describes how to identify the Grandstream phone model, requirements that must be
met, and how to register a phone using Manual configuration or Auto provisioning.
The following topics are covered:

Manual Configuration

Auto Provisioning
Manual Configuration
This section describes how to set UAD settings, create the PBXware Extension, and register the