Siemens VDO modulcockpit II Product Manual page 102

Table of Contents

Advertisement

Technical Product Manual
VDO modulcockpit II
5.
Testing Instructions
5.10 Test Accessories, Programming Accessories
Software
System requirements:
MS-DOS compatible PC,
processor 386SX or better,
mathematical coprocessor (recommended),
MS-DOS 5.0 or more recent,
one serial port COM 1 or COM 2,
one parallel port LPT1 (recommended),
3.5" diskette drive,
1 MB hard disk capacity,
380 kB free memory,
mouse (recommended).
Software package (full version):
diskette, support with current supply
wire and individual workshop stamp
set (on request)
Programming of all elctronic tachometers
with operating hours counter and electronic
speedometers of the VDO modulcockpit II
serie.
The following parameters can be changed
with this software:
-
Measuring range
-
Frequency or distance/pulse ratio
-
Disable programming by pushbutton
-
Operating hours (tachometer)
-
Total distance (speedometer)
-
Electronic operating hours counter threshold
-
Pointer zero position
A diagnosis, storage and documentation of data sets is possible in addition. The use is simplified by an online
help system.
Software package: diskette and support with current supply wire (on request)
Programming of all electronic tachometers with operating hours counter and electronic speedometers of the
VDO modulcockpit II serie.
The following parameters can be changed with this software:
-
Frequency or distance/pulse ratio
-
Operating hours (tachometer)
-
Total distance (speedometer)
A diagnosis, storage and documentation of data sets is possible in addition. The use is simplified by an online
help system.
TU00-0740-0000002
0904
5 - 25

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VDO modulcockpit II and is the answer not in the manual?

Table of Contents