Siemens Veeder-Root Driver Installation Instructions

Veeder-Root Driver for PXC Modular
These installation instructions cover the connection of
the Veeder-Root Driver or the Veeder-Root Enterprise
Driver to the Veeder-Root system only. For hardware
installation of the PXC Modular, see PXC Modular
Series Installation and Quick Start (553-638).

Product Description

The Veeder-Root Driver enables communication
®
between the APOGEE
Veeder-Root system.

Product Numbers

PXC00-PE96.A PXC Modular RS-485 or
Ethernet ALN, 96 FLN nodes
PXC00-E96.A PXC Modular with BACnet/IP
ALN and BACnet MS/TP ALN,
96 FLN nodes
PXC100-PE96.A PXC Modular RS-485 or
Ethernet ALN, TX-I/O Support,
96 FLN nodes
PXC100-E96.A PXC Modular BACnet/IP ALN
and BACnet MS/TP ALN, TX-I/O
Support, 96 FLN nodes
PXX-485.3 Expansion Module, three
RS-485 FLN connections
LSM-INT-VR Veeder-Root PXC Modular
Driver License
LSM-INT-VRE Veeder-Root Enterprise PXC
Modular Driver License

Accessories

538-670 Trunk Interface II, 115V
538-675 Trunk Interface II, 230V
Item Number: 565-714, Rev. AA
Automation System and the
Installation Instructions

Warning/Caution Notations

WARNING:
Personal injury/loss of life may occur if you
do not follow the procedures as specified.
CAUTION:
Equipment damage or loss of data may
occur if you do not follow the procedures
as specified.

Expected Installation Times

The expected installation time is 30 minutes.

Required Tools and Materials

• Flat-blade screwdriver (1/8-inch blade width).
• Wire strippers.
• Cabling and connectors. See the Connecting
the Veeder-Root Driver to the Veeder-Root
Devices section.
CAUTION:
Always wear an electro-static discharge
wrist strap and discharge accumulated
static before touching field panel
components.

Prerequisites

• Driver hardware is installed according to its
respective installation instructions.
• FLN Termination blocks installed, if any.
Depending on the type of installation, other
prerequisites may have to be completed.
Document No. 565-714
October 31, 2009
Page 1 of 4