Table of Contents
Advertisement
FusionServer Pro 2288X V5 Server
User Guide
Common Methods
The methods of laying out cables inside a cabinet are described as follows:
●
●
●
7.2.6.2 Connecting Mouse, Keyboard, and VGA Cables
The front and rear panels of the server provide DB15 VGA ports but no standard
PS/2 port for a keyboard or mouse.
You can connect a keyboard and mouse to the USB port on the front or rear panel
based on site installation conditions. There are two connection methods:
●
●
This section describes how to connect a keyboard and mouse using a USB-to-PS/2
cable and connect a monitor using a VGA cable.
Procedure
Step 1 Connect the USB connector of the USB-to-PS/2 cable to a USB port on the front or
rear panel of the server.
Step 2 Connect the PS/2 connectors of the USB-to-PS/2 cable to the keyboard and
mouse.
Step 3 Connect the DB15 connector of the VGA cable to the VGA port on the front or
rear panel of the server and tighten the two screws.
Step 4 Connect the other connector of the VGA cable to the VGA port on the monitor
and tighten the two screws.
Issue 04 (2020-06-05)
Choose overhead or underfloor cabling for power cables based on equipment
room conditions (such as the AC power distribution frame, surge protector,
and terminal blocks).
Choose overhead or underfloor cabling for service data cables (for example,
signal cables) based on equipment room conditions.
Place the connectors of all service data cables at the bottom of the cabinet so
that the connectors are difficult to reach.
Connect the keyboard and mouse to the USB ports.
Connect the keyboard and mouse using a USB-to-PS/2 cable.
Copyright © Huawei Technologies Co., Ltd.
7 Installation and Configuration
85
Advertisement
Table of Contents
