Table of Contents
Advertisement
FusionServer Pro 2288X V5 Server
User Guide
7.3.2 Power-Off Procedure
The server can be powered off in any of the following ways:
●
●
●
●
Issue 04 (2020-06-05)
iii. Click Power On.
A confirmation message is displayed.
iv.
Click Yes.
–
Use the iBMC CLI.
i.
Log in to the iBMC CLI.
For details, see
ii.
Run the following command:
ipmcset -d powerstate -v 1
iii. Type y or Y and press Enter.
–
Use the Remote Virtual Console.
i.
Log in to the Remote Virtual Console.
For details, see
ii.
On the KVM screen, click
iii. Select Power On.
A dialog box is displayed.
iv.
Click Yes.
● Powering off a server will interrupt all services and programs running on it. Therefore,
before powering off a server, ensure that all services and programs have been stopped
or migrated to other servers.
● The "power-off" mentioned here is an operation performed to change the server to the
standby state (the power indicator is steady yellow).
● After a server is powered off forcibly, wait for more than 10 seconds for the server to
power off completely. Do not power on the server again before it is completely powered
off.
● Forced power-off may damage user programs or unsaved data. Exercise caution when
performing this operation.
Connect a keyboard, video, and mouse (KVM) to the server and shut down
the operating system of the server using the KVM.
When the server is in power-on state, pressing the power button on the server
front panel can power off the server gracefully.
If the server OS is running, shut down the OS according to the onscreen instructions.
For details, see
2.1.2 Indicators and
When the server is in power-on state, holding down the power button on the
server front panel for six seconds can power off the server forcibly.
For details, see
2.1.2 Indicators and
Use the iBMC WebUI.
Copyright © Huawei Technologies Co., Ltd.
9.4 Logging In to the
9.3 Logging In to the Desktop of a
or
on the toolbar.
Buttons.
Buttons.
7 Installation and Configuration
CLI.
Server.
96
Advertisement
Table of Contents
