Setpoint Selection (Level 0); External Actual Temperature Display - Lauda Integral T 1200 Operating Instructions Manual

Integral T process thermostats
7.5.1

Setpoint selection (Level 0)


 For safety reasons the setpoint can only be set up to 2 °C above the upper limit of
7.5.2

External actual temperature display

21/01/2019 / YAWE 0026
or
or
the operating temperature range of the particular equipment type.
 Press keys until SET (Setpoint) appears.
 Enter, display is flashing.
 Enter setpoint with both keys ( Section 7.3.1).
 Display is flashing 4 s  new value is entered
automatically, or
 value entered immediately with key.
 Appears when analogue setpoint input is activated.
 switches line 2 of the display from setpoint SET to the
external actual temperature T
 or internal actual temperature (outflow temperature) T
external control is activated.
Starting up
,
E
if
I
35