Lauda Integral T 1200 Operating Instructions Manual page 61

Integral T process thermostats
21/01/2019 / YAWE 0026

Analogue setpoint input is switched on, with current input
(I) configuration. With voltage the display shows AIS U.

Scroll to AIE
or

pressing the key leads to submenu setpoint, "Analogue
inputs" ( Section 7.6.5.1).

AIE = analogue Input external actual temperature as
standard signal/ instead of Pt100 on input 10S.
OFF = this input is switched off, the measurement of the
Pt100 at socket 10S is valid.

Input is switched on. With current configuration (I). In case
of voltage the display shows AIE U.

Pressing the key leads to the submenu "analogue inputs"
external actual temperature ( Section 7.6.5.1)
or

A01 = analogue output 1

OFF = switched off.

Analogue output 1 is switched on. With voltage output (U)
configured and the internal temperature signal, i.e. outflow
temperature (t I).

I = current output
tE = external actual temperature
tS = setpoint
P = pressure
Y = electrical output

Outputs 2 and 3 are similar to output 1.
Starting up
61