Table of Contents
Advertisement
Maximum Transmission Unit (MTU)
PC Port Mode
PC Port Mode
PC Port VLAN Tag
PC Port Priority Value
Proxy
HTTP Proxy
HTTPS Proxy
Bypass Proxy for
Remote Control
Action URI Support
Remote Control Pop up Window
Support
Action URI Allowed IP List
CSTA Control
CTI Settings
Affinity Support
Preferred Account
Network Settings �� SNMP Settings
Enable SNMP
Version
Port
Community
value is 0
Defines the MTU in bytes. The valid range is 576 – 1500.
The default value is 1500 bytes.
Configure the PC port mode. When set to "Mirrored", the traffic in the LAN port will go
through PC port as well and packets can be captured by connecting a PC to the PC port. The
default setting is "Enabled".
Assigns the VLAN Tag of the PC port. The valid range is 0 – 4094.
The default value is 0.
Assigns the priority value of the PC port. The valid range is 0 – 7.
The default value is 0.
Specifies the HTTP proxy URL for the phone to send packets to. The proxy server will act as
an intermediary to route the packets to the destination.
Specifies the HTTPS proxy URL for the phone to send packets to. The proxy server will act as
an intermediary to route the packets to the destination.
Configures the destination IP address where no proxy server is needed. The phone will not use
a proxy server when sending packets to the specified destination IP address.
Indicate whether the phone is enabled to receive and handle Action URI request.
Indicate whether the phone is enabled to pop up Allow Remote Control window.
List of allowed IP addresses from which the phone receives the Action URI
Indicates whether CSTA Control feature is enabled. Change of this configuration will need the
system reboot to make it take effect.
Indicate whether Affinity feature is supported.
Affinity target SIP account.
Enable/Disable SNMP service. Default is No.
Choose between (Version 1, Version 2, or Version 3).
Listening Port of SNMP daemon (Default 161).
Name of SNMP community.
Advertisement
Table of Contents
