Table of Contents
Advertisement
DND Call Feature Off
Call Forward Always
On
Off
Target
Call Forward No Answer
On
Off
Target
Call Forward No Answer Timeout (s)
Swap Account Settings
Phone Settings Page Definitions
Phone Settings �� General settings
Basic Settings
This parameter defines the local RTP port used to listen and transmit. It is the base RTP port for channel 0. When
Local RTP Port
configured, channel 0 will use this port _value for RTP; channel 1 will use port_value+2 for RTP. Local RTP port
ranges from 1024 to 65400 and must be even. Default value is 5004.
Gives users the ability to define the parameter of the local RTP port used to listen and transmit. This parameter defines
Local RTP Port
the local RTP port from 48 to 10000. This range will be adjusted if local RTP port + local RTP port range is greater
Range
than 65486. Default setting is 200.
When set to "Yes", this parameter will force random generation of both the local SIP and RTP ports. This is usually
Use Random
necessary when multiple phones are behind the same full cone NAT. The default setting is "Yes"
Port
Note: This parameter must be set to "No" for Direct IP Calling to work.
Keep-alive
Specifies how often the phone sends a blank UDP packet to the SIP server to keep the "ping hole" on the NAT router
Interval
to open. The default setting is 20 seconds. The valid range is from 10 to 160.
The IP address or Domain name of the STUN server. STUN resolution results are displayed in the STATUS page of
the Web GUI.
STUN Server
Only non-symmetric NAT routers work with STUN.
Configures DND feature code to turn off DND.
Configures Call Forward Always feature code to activate unconditional call forwarding.
Configures Call Forward Always feature code to deactivate unconditional call forwarding.
The extension the call will be forwarded to.
Configures Call Forward No Answer feature code to activate no answer call forwarding.
Configures Call Forward No Answer feature code to deactivate no answer call forwarding.
The extension the call will be forwarded to.
Defines the timeout (in seconds) before the call is forwarded on no answer. valid range is 1 to
120.
Accounts �� Account Swap
Allows users to swap the two accounts that they have configured. This will Increase the
flexibility of account management.
Note: Make sure to press "Start" to complete the process.
Table 9: Account page definitions
Advertisement
Table of Contents
