Grandstream Networks GRP260X Series Administration Manual page 35

Hide thumbs Also See for GRP260X Series:
Table of Contents

Advertisement

● Busy Tone
● Reorder Tone
Provision
Total Number of
Configures the number of custom ringtones to update in the provisioning process.
Custom
Default Value is 6.
Ringtone Update
Phone settings -> Multicast Paging
Multicast Paging
Enable or disable multicast paging
Function
Allow Multicast Paging when DND mode is enabled.
Allowed In DND
Mode
Default Setting is "No".
During active call, if incoming multicast page is higher priority (1 being the highest) than this value, the call will be
Paging Barge
held, and multicast page will be played. The default setting is "Disabled".
Paging Priority
If enabled, during a multicast page if another multicast is received with higher priority (1 being the highest) that one
Active
will be played instead. The default setting is "Enabled".
Multicast
Channel
Multicast Channel Number (0-50). 0 for normal RTP packets, 1-50 for Polycom multicast format packets.
Number
Multicast Paging
The codec for sending multicast pages, there are 5 codecs could be used: G.731.1 PCMU, PCMA, G.726-32,
Codec
G.729A/B, G.722 (wide band). Default setting is "PCMU".
Multicast Sender
Outgoing caller ID that displays to your page group recipients (for multicast channel 1 – 50).
ID
Defines multicast listening addresses and labels. For example:
● "Listening Address" should match the sender's Value such as
Multicast
"237.11.10.11:6767"
Listening
● "Label" could be the description you want to use.
For details, please check the "Multicast Paging User Guide" on our Website.
Network Settings Page Definitions
Network Settings �� Ethernet Settings
Internet Protocol
IPv4 Address
IPv4 Address
Host name (Option 12)
Table 10: Phone settings definitions
Selects "IPv4 Only", "IPv6 Only", "Both, prefer IPv4" or "Both, prefer IPv6". The default
setting is "IPv4 only".
Allows users to configure the appropriate network settings on the phone to obtain IPv4
address. Users could select "DHCP", "Static IP" or "PPPoE". By default, it is set to "DHCP".
Specifies the name of the client. This field is optional but may be required by Internet Service
Providers.

Advertisement

Table of Contents
loading

Table of Contents