Grandstream Networks GRP260X Series Administration Manual page 34

The default setting is off.
Override DND
Configure the number to override the local DND function.
Numbers
Conference
Enable
Enables the conference feature
Conference
Configures whether to put the current call on hold while adding new members to a conference. If set to "Yes", the
current call will be put on hold when the host presses conference or add key to invite new members. When the invited
Hold Call Before
member answers the call and agrees to attend the conference, the host needs to manually resume the conference with
Conferee
the new member added. If set to "No", the current call will not be put on hold and the invited member will join the
meeting automatically after answering the call.
BLF
Enable BLF
Configures to show a softkey which leads to a monitor screen when a monitering BLF line is ringing.
Pickup Screen
Enable BLF
Configures to play sound when a monitering BLF line is ringing.
Pickup Sound
Hide BLF
Configures to hide the status information of the monitored line.
Remote Status
IM
Enable IM
If enabled, the phone will show a pop up upon receiving an IM.
Popup
Instant Message
Configures the number of seconds that the message will remain on screen.
Popup Timeout
Play Tone on
Configures to play a short tone when phone receives an IM during idle state
Receiving IM
Phone settings -> Ringtone
Ringtone
Call Progresses Configures ring or tone frequencies based on parameters from local telecom. The default value is North American
Tones: standard. Frequencies should be configured with known values to avoid uncomfortable high pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
● System Ring
(Frequencies are in Hz and cadence on and off are in 10ms)
Tone
ON is the period of ringing ("On time" in 'ms') while OFF is the period of silence.
● Dial Tone
To set a continuous ring, OFF should be zero. Otherwise, it will ring ON ms and a pause of OFF ms and then repeat
● Second Dial
the pattern. Up to three cadences are supported.
Tone
Call Waiting tone gain can be set to either: Low, Medium, or High, it is set to Low by Default
● Message
Auto-Answer Tone Gain can be set to either: Low, Medium, or High, Set to Medium by Default
Waiting
● Ring Back
Tone
● Call-Waiting
Tone
● Call Waiting
Tone Gain
● Auto-Answer
Tone Gain