Grandstream Networks GRP260X Series Administration Manual page 31

Preferred Select the preferred default account for on-hook or off-hook dialing. When the selected account is unavailable, system
Default Account will use the first available account to dial out.
Select "Mute" key function while the phone is idle.
Mute Key
● DND: Pressing the "Mute" key when the phone is idle will enable DND.
Functions While
● Idle Mute: Pressing the "Mute" key when the phone is idle will set the phone to be muted when answering
Idle
incoming calls.
● Disabled
Last Call If enabled, the number put into the ForwardAll feature will be stored the next time you use the ForwardAll softkey.
Froward Always Note: ForwardAll softkey currently only used for account 1.
Show SIP Error
Configures to enable SIP error response information displayed on LCD screen.
Response
Do Not Escape
'#' as %23 in SIP Replaces # by %23 for some special situations.
URI
User-Agent
Configures the prefix in the User-Agent header.
Prefix
Enable Hook When set to "No", disable hook switch completely; When set to "Yes, except answering call", hook switch cannot be
Switch used for answering call.
Sets whether to enable the speaker key.
Enable Speaker
● When "Yes" is selected, the speaker key can be used to make calls, end calls, and switch channels;
Key
● when "No" is selected, the speaker key is completely disabled; when "For Switching Channels"is selected, the user
cannot use the speaker key to hang up the call.
Configure the priority if the ID source displayed on the phone when incming/outgoing calls. Select on ID source and
Contact Source click Up/Down arrow on the right to adjust the order.
Priority Note: If the "Caller ID Display" under the account is configured as "Disabled", the caller number cannot be obtained,
the phone will only display "Unavailable".
Outgoing
Click-To-Dial Enables Click-To-Dial feature. If this feature is enabled, user could click the green dial button on left top corner of
Feature phone's Web GUI, then choose the account and dial to the target number. The default setting is "Disabled".
Enable Direct IP
Enables Direct IP Call feature.
Call
Use Quick IP When set to "Yes", users can dial an IP address under the same LAN/VPN segment by entering the last octet of the IP
Call Mode address.
Enable Paging Configures enable/disable paging call mode of the phone. If set to "Yes", the feature of paging call will be enabled.
Call Mode Default is Yes.
Predictive
Configures the predictive dialing feature on the call screen.
Dialing Feature
Predictive
Predictive dialing feature will sequentially search the number based on the selected sources.
Dialing Source