Table of Contents
Advertisement
Parameter
level (P-level)
H
H
H
The parameter level can be accessed from the operating level with the aid of
the h + R keys, from the configuration level 1 by using e.
The parameter level and configuration levels are protected by a four-figure
code number.
There are two different code numbers:
- Code number for the restricted parameter set (factory setting 9200)
- Code number for the full parameter set (factory setting 9210)
The parameters which belong to the restricted parameter set are defined in the
setup program under Edit
Here, parameters which are not needed for the application, or only have to be
programmed once, can be appropriately marked. They will no longer be dis-
played on the recorder after the new setup has been transferred.
If one of the two code numbers is entered, then
- signal acquisition and
- recording
will be interrupted.
Furthermore
- events will no longer be recorded,
- reports will be aborted and reset,
- limits will no longer be monitored,
- the Code for the mathematics module will no longer be applied,
- the fault signal output will be set to fault, and
- all other outputs will remain in their last state.
The parameters can now be programmed.
If the wrong code number is entered, then the recorder will remain
in the normal mode. Signal acquisition, processing and recording
are still active.
The parameters can be looked at, but not programmed.
The code numbers can be altered through the setup program
(Edit
Code numbers ...) or on the instrument.
v Section 4.2 "Table of the configuration parameters"
If customer-specific code numbers are entered, then the original
JUMO code numbers will be overwritten, and are no longer valid.
2 Instrument description
Instrument operation ...
19
Advertisement
Table of Contents
