Table of Contents
Advertisement
12.2 Hardware fault
If one of the following faults occurs, then the recording is aborted and the error
message will be shown in a flashing display.
The relay will react as in the event of a probe break
responds to any kind of event, and cannot even be operated or controlled.
Please contact the nearest JUMO office or the main factory.
Display
EEPROM-ERROR!
NO ZERO!
1. The reaction to a probe break is configured in the setup program or through the
parameter Configuration level 1
"Table of the configuration parameters")
1
Cause / Remedy
- The EEPROM in the printing recorder is
faulty, the configuration data can no longer
be stored.
- Please contact the nearest JUMO office or
the main factory.
- The limit sensor (print head) was not
recognised.
- Please contact the nearest JUMO office or
the main factory,
Limit comparator
12 Appendix
. The instrument no longer
Probe break (
Section 4.2
103
Advertisement
Table of Contents
