Kia Stinger 2023 Owner's Manual page 128

Features of your vehicle
ENGINE START/STOP button is in ACC
position or ON position.
CAUTION
Before programming HomeLink to a
garage door opener or gate operator,
make sure that people and objects are
out of the way of the device to prevent
potential harm or damage. When pro-
gramming a garage door opener, it is
advised to park outside of the garage.
Do not use HomeLink with any garage
door opener that lacks safety stop and
reverse features as required by U.S. fed-
eral safety standards (this includes any
garage door opener model manufac-
tured before April 1, 1982). A garage
door that cannot detect an object signal-
ing the door to stop and reverse - does
not meet current U.S. federal safety
standards. For more information, con-
tact HomeLink at www.homelink.com,
or call HomeLink customer support at 1-
800-355-3515.
It is also recommended that a new bat-
tery be replaced in the hand-held trans-
mitter of the device being trained to
HomeLink for quicker training and accu-
rate transmission of the radio frequency.
1. Programming HomeLink씾
The following steps show how to pro-
gram HomeLink. If you have any ques-
tions or are having difficulty
programming your HomeLink buttons,
refer to the HomeLink website or call the
HomeLink customer support toll-free
number. Do this, before going back to
the dealer who sold you the car.
僅 Visit the HomeLink website at:
www.homelink.com. Then at the top
of the page, choose your vehicle
make. Then watch the You Tube
video, and/or access additional web-
site information.
僅 If you choose to access the website
via your cell phone, scan the QR code.
僅 Or, call HomeLink customer support
at 1-800-355-3515
(Please have the vehicle make/model
AND the opener device make/model
readily available.)
1) Programming Preparation
1. When programming a garage door
opener, it is advised to park the vehi-
cle outside of the garage.
2. It is recommended that a new battery
be placed in the hand-held transmit-
ter of the device being programmed
to HomeLink for quicker training and
accurate transmission of the radio-
frequency signal.
3. Place the ENGINE START/STOP but-
ton to the ACC (Accessory) position
for programming of HomeLink.
OCK040066N
Mirrors
4
4 49