Kia Stinger 2023 Owner's Manual page 133

Features of your vehicle
2) The following instructions will
erase ALL HomeLink씾 program-
ming from ALL buttons:
OCK040071N
1. Press and hold the buttons (1) and (3)
simultaneously
2. The HomeLink indicator light (7) will
appear solid Orange for about 10 sec-
onds
3. Release the buttons once the Home-
Link indicator light (7) changes to
Green and flashes rapidly
4. Now all three HomeLink buttons (1),
(2) and (3) are cleared of any pro-
gramming
Information
HomeLink and the HomeLink House
logo are registered trademarks of Gen-
tex Corporation.
The myQ logo is a registered trademark
of The Chamberlain Group, Inc
FCC (USA) and ISED (Canada)
This device complies with FCC rules part
15 and Innovation, Science, and Eco-
nomic Development Canada RSS-210.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) This device
must accept any interference that may
be received including interference that
may cause undesired operation. WARN-
ING: The transmitter has been tested
4 54
and complies with FCC and ISED rules.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's author-
ity to operate the device.
This equipment complies with FCC and
ISED radiation exposure limits set forth
for an uncontrolled environment. End
Users must follow the specific operating
instructions for satisfying RF exposure
compliance. This transmitter must be at
least 20 cm from the user and must not
be co-located or operating in conjunc-
tion with any other antenna or transmit-
ter.
FCC (쉩tats-Unis) et ISED (Canada)
Cet appareil est conforme aux r썟gle-
ments de la FCC, section 15, et au CNR-
210 d'Innovation, Sciences et D썗veloppe-
ment 썗conomique Canada. Le
fonctionnement est assujetti aux deux
conditions suivantes: (1) cet appareil ne
doit pas causer d'interf썗rences nuisibles
et (2) cet appareil doit accepter toute
interf썗rence re썋ue, y compris celle qui
pourrait entra쎂ner un dysfonctionne-
ment. MISE EN GARDE: L'썗metteur a
subi des tests et est conforme aux r썟gle-
ments de la FCC et d'ISDE. Les change-
ments ou modifications non approuv썗s
explicitement par la partie responsable
de la conformit썗 pourraient rendre
caduque l'autorisation de l'utilisateur de
se servir du dispositif.
Cet appareil est conforme aux limites
d'exposition aux radiations de la FCC et
d'ISDE 썗tablies pour un environnement
non contr쎦l썗. Les utilisateurs finaux
doivent respecter les instructions d'utili-
sation sp썗cifiques pour satisfaire aux
exigences de conformit썗 aux expositions
de RF. L'썗metteur doit se trouver 쌽 20
cm au minimum de l'utilisateur et ne doit
Mirrors