Kia Stinger 2023 Owner's Manual page 396

What to do in an emergency
OCK060026N
7. Place the jack at the front (1) or rear
(2) jacking position closest to the tire
you are changing. Place the jack at
the designated locations under the
frame. The jacking positions are
plates welded to the frame with two
tabs and a raised dot to line up with
the jack.
OCK061027N
OCK061028N
If you have a flat tire (with spare tire)
8. Insert the wheel lug nut wrench into
the jack and turn it clockwise, raising
the vehicle until the tire just clears the
ground. This measurement is approxi-
mately 1 in (30 mm).
Before removing the wheel lug nuts,
make sure the vehicle is stable and
that there is no chance for movement
or slippage.
OCK060029N
9. Loosen the wheel nuts and remove
them with your fingers. Slide the
wheel off the studs and lay it flat so it
cannot roll away. To put the wheel on
the hub, pick up the spare tire, line up
the holes with the studs and slide the
wheel onto them. If this is difficult, tip
the wheel slightly and get the top hole
in the wheel lined up with the top
stud. Jiggle the wheel back and forth
until the wheel can slide over the
other studs.
Wheels may have sharp edges. Han-
dle them carefully to avoid possible
severe injury. Before putting the
wheel into place, be sure that there is
nothing on the hub or wheel (such as
mud, tar, gravel, etc.) that prevents
the wheel from fitting solidly against
the hub.
6
6 15