Kia Stinger 2023 Owner's Manual page 129

Features of your vehicle
2) Programming a New Home-
Link씾 Button
1. Press and release the HomeLink but-
ton (1), (2) or (3), you would like to
program. The HomeLink indicator
light (7) will flash orange slowly (if not,
perform the steps of "Erasing Home-
Link Buttons" section, and start over).
OCK040068N
2. Position the garage door opener
remote 1 - 3 inches (2 - 8 cm) away
from the HomeLink buttons.
OCK040067N
3. While the HomeLink indicator light (7)
is flashing orange, press and hold the
hand-held remote button. Continue
pressing the hand-held remote button
until the HomeLink indicator light (7)
light changes from orange to green.
You ma"y now release the hand-held
remote button.
4. Wait until your garage door comes to
a complete stop, regardless of posi-
4 50
tion, before proceeding to the next
steps.
5. Press and release the HomeLink but-
ton you are programming and
observe the indicator light.
僅 If the indicator light remains solid
green, your device should operate
when the HomeLink button is
pressed. At this point, if your device
operates, programming is com-
plete.
僅 If the indicator light rapidly flashes
green, firmly press, hold for two
seconds and release the HomeLink
button up to three times in a row
slowly to complete the program-
ming process. Do not press the
HomeLink button rapidly. At this
point if your device operates, pro-
gramming is complete. If the device
does not operate, continue with
step 6.
6. At the garage door opener motor,
(security gate motor, etc.) locate the
"Learn", "Smart", "Set" or "Program"
button. This can usually be found
where the hanging antenna wire is
attached to the motor-head unit (see
the device's manual to identify this
button). The name and color of the
button may vary by manufacturer.
ODL3A040504
Mirrors