Kia Stinger 2023 Owner's Manual page 130

Features of your vehicle
* A ladder and/or second person may
simplify the following steps.
7. Firmly press and release the "Learn",
"Smart", "Set" or "Program"" button.
You now have up to 30 seconds in
which to complete the next step.
8. Return to the vehicle and firmly press,
hold for two seconds and release, the
HomeLink button up to three times in
a row slowly. Do not press the Home-
Link button rapidly. As soon as you
see the garage door start to move,
stop pressing any buttons until a few
seconds after the garage door has
come to a complete stop, regardless
of position. At this point programming
is complete and your device should
operate when the HomeLink button is
pressed and released.
3) Two-Way Communication Pro-
gramming (For select garage
door openers)
If your garage door opener has the
'myQ' logo on its side, your opener likely
has Two-Way Communication capability.
HomeLink has the capability to establish
Two-Way Communication with your
garage door opener. HomeLink can
receive and display "closing" or "open-
ing" status messages from compatible
garage door openers. At any time,
HomeLink can also recall and display the
last recorded status communicated by
the garage door opener to indicate your
garage door being "closed" or "opened".
To check if your garage door opener is
compatible with this feature, refer to
www.homelink.com/compatible/Two-
way-Communication. If your garage
door opener has this functionality, AND
the Two-Way Communication indicators
(4), (6) in the mirror appear while the
garage door is opening/closing, then no
further steps are needed. Two-Way
Communication Programming is already
complete. However, if your garage door
opener has this functionality, AND the
Two-Way Communication indicators (4),
(6) in the mirror DO NOT appear while
the garage door is opening/closing, use
the following instructions to enable this
functionality.
1. In your vehicle, press and hold the
programmed HomeLink button for 2
seconds, then release. Confirm that
the garage door is moving. AFTER it
stops, you will have one minute to
complete the following steps:
* A ladder and/or second person may
simplify the following steps.
2. On your garage door opener in your
garage, locate the "Learn" button
(usually near where the hanging
antenna wire is attached to the
garage door opener). If there is diffi-
culty locating this button, reference
the device's owner's manual.
3. Press and release the "Learn" button.
4. A light on your garage door opener
may flash, and your Two-Way Com-
munication indicators (4), (6) in your
vehicle may flash, confirming comple-
tion of the process.
5. Return to the vehicle and firmly press
and release the programmed Home-
Link button to activate your garage
door. The Two-Way Communication
indicators (4), (6) flash in orange
when the door is moving. Do not
make any additional button presses
until AFTER the garage door has
come to a complete stop.
6. Your Two-Way Communication pro-
gramming is now complete.
Mirrors
4
4 51