Kia Stinger 2023 Owner's Manual page 192

Features of your vehicle
certain time) and (
appear.
If this occurs, we recommended that the
function be inspected by an authorized
Kia dealer.
Limitations of High Beam Assist
High Beam Assist may not work properly
in the following situations:
僅 Light from a vehicle is not detected
because of lamp damage, or because
it is hidden from sight, etc.
僅 Headlamp of a vehicle is covered with
dust, snow or water.
僅 A vehicle's headlamps are off but the
fog lamps are on and etc.
僅 There is a lamp that has a similar
shape as a vehicle's lamp.
僅 Headlamps have been damaged or
not repaired properly.
僅 Headlamps are not aimed properly.
僅 Driving on a narrow curved road,
rough road, uphill or downhill.
僅 Vehicle in front is partially visible on a
crossroad or curved road.
僅 There is a traffic light, reflecting sign,
flashing sign or mirror ahead.
僅 There is a temporary reflector or flash
ahead (construction area).
僅 The road conditions are bad such as
being wet, iced or covered with snow.
僅 A vehicle suddenly appears from a
curve.
僅 The vehicle is tilted from a flat tire or
is being towed.
僅 Light from a vehicle is not detected
because of exhaust fume, smoke, fog,
snow, etc.
NOTICE
For more details on the limitations of the
front view camera, refer to "Forward Col-
) warning light will
lision-Avoidance Assist (FCA) (Sensor
fusion)" on page 5-54.
WARNING
僅 At times, High Beam Assist may not
work properly. The function is for your
convenience only. It is the responsibil-
ity of the driver for safe driving prac-
tices and always check the road
conditions for your safety.
僅 When High Beam Assist does not
operate normally, change the head-
lamp position manually between high
beam and low beam.
Turn signals and lane change sig-
nals
OCK040516N
The ENGINE START/STOP button must
be on for the turn signals to function. To
turn on the turn signals, move the lever
up or down (A). The green arrow indica-
tors on the instrument panel indicate
which turn signal is operating. They will
self-cancel after a turn is completed. If
the indicator continues to flash after a
turn, manually return the lever to the
OFF position.
To signal a lane change, move the turn
signal lever slightly and hold it in posi-
Lighting
4
4 113