Kia Stinger 2023 Owner's Manual page 407

What to do in an emergency
Checking the tire inflation pres-
sure
1. After driving approximately 4 ~ 6
miles (7 ~ 10 km or about 10 minutes),
stop at a suitable location.
2. Connect the filling hose (3) of the
compressor (clip mounted side)
directly and then connect the filling
hose (3) (opposite side) to the tire
valve.
3. Connect between compressor and the
vehicle power outlet using the cable
and connectors.
4. Adjust the tire inflation pressure to 29
psi (200 kPa). With the ENGINE
START/STOP button ON position, pro-
ceed as follows.
僅 To increase the inflation pres-
sure: Switch on the compressor,
position I. To check the current
inflation pressure setting, briefly
switch off the compressor.
WARNING
Do not let the compressor run for more
than 10 minutes, otherwise the device
will overheat and may be damaged.
僅 To reduce the inflation pressure:
Press the button (9) on the com-
pressor.
WARNING
The tire inflation pressure must be at
least 29 psi (200 kPa, 2 bar). If it is not,
do not continue driving.
Call for road side service or towing.
Technical Data
System voltage: DC 12 V
Working voltage: DC 10 - 15 V
Amperage rating: max. 15 A ± 1A (at DC
12V operation)
6 26
If you have a flat tire (with Tire Mobility Kit)
Suitable for use at temperatures: -22 ~
+158°F (-30 ~ +70°C)
Max. working pressure: 87 psi (6 bar)
Size
Compressor: 6.3 x 5.9 x 2.2 in (161 x 150
x 55.8 mm)
Sealant bottle: 4.1 x 3.3 ø in (104 x 85 ø
mm)
Compressor weight: 1.77 lbs ± 0.07 lbs
(805 g ± 30 g)
Sealant volume: 18.3 cu. in (300 ml)
* Sealant and spare parts can be
obtained and replaced at an autho-
rized vehicle or tire dealer. Empty seal-
ant bottles may be disposed of at
home. Liquid residue from the sealant
should be disposed of by your vehicle
or tire dealer or in accordance with
local waste disposal regulations.