Single and Dual Input Analyzers for pH/Redox (ORP)
AX416, AX436, AX460, AX466 & AX468
6.2.2 Panel-mount Analyzers
Dimensions in mm (in.)
96 (3.78)
5.40 (0.2)
Fig. 6.4 Overall Dimensions
Note. The clamp must fit flat on the analyzer casing. If the clamp is bowed, the securing screw is overtight and sealing problems
may occur.
Cut a hole in the panel (see Fig. 6.4 for dimensions).
1
Instruments may be close stacked to DIN 43835
Refit the panel clamps to the case, ensuring that the
5
panel clamp anchors are located correctly in their slots
Secure the analyzer by tightening the panel clamp
6
retaining screws (see
Fig. 6.5 Panel-mounting
46
Remove the panel clamp and
anchors from the instrument case
Loosen the
2
retaining screw on
each panel clamp
below)
Note
25
137.50 (5.41)
(0.98)
3
6 INSTALLATION
+0.8
+0.03
92
(3.62
)
–0
–0
+0.8
92
–0
Panel Cut-out
+0.03
(3.62
)
–0
Insert the instrument
4
into the panel cut-out
IM/AX4PH
Issue 9