Appendix F: Winspec/32/Lightfield Cross Reference; Winspec/32-To-Lightfield Terminology; Table F-1: Winspec/32-To-Lightfield Cross Reference - Teledyne PIXIS Manual

Appendix F:
This appendix provides cross reference information for terminology used within the
WinSpec/32 and LightField application software packages.
F.1

WinSpec/32-to-LightField Terminology

Refer to
terms.
Table F-1:
Active Rows Parallel to Shift Register
Active Shift Register Columns
ADC Rate
ADC Resolution
Continuous Cleans
Controller Gain
Custom Chip
Custom Timing
Disabled Closed (Shutter)
Disabled Open (Shutter)
Dual Trigger Mode
Easy Bin
Edge Trigger
External Sync
F.T. Dummies or Frame Transfer Dummies
Focus
Free Run
Logic Out
Logic Out: Logic 0
Logic Out: Logic 1
Logic Out: Not Ready
Logic Out: Not Scan
WinSpec/32/LightField
Cross Reference
Table F-1 for a list of WinSpec/32 terms and their corresponding LightField
WinSpec/32-to-LightField Cross Reference (Sheet 1 of 2)
WinSpec/32 Term LightField Term
Active Height
Active Width
Speed
Bit Depth
Clean Until Trigger
Analog Gain
Custom Sensor
Custom Timing
Always Closed (Shutter)
Always Open (Shutter)
Shift Per Trigger
Sensor Readout Region expander functions
Trigger Determined By
Readout Per Trigger
Active Area: Top Margin
Preview or Run
No Response
Output Signal
Output Signal: Always Low
Output Signal: Always High
Output Signal: Busy
Output Signal: Not Reading Out
147