Table of Contents
Advertisement
Assembly
Figure 29. Attaching a 6,2m Falcon Fall Arrest Block at a lower
4. Make sure that the steps in the safety check in the Maintenance
chapter are followed and executed. Now the SkyReach Anchor
is ready to use!
NOTE
Make sure that the Lock Pin is properly installed, latch is dropped
and that it is secured with the wire. Under no circumstances can
a Lock Pin other than provided by Combisafe be used.
The SkyReach Anchor should be able to rotate freely after
installation, make sure that nothing prevents the rotation.
Installation by crane
With this method the SkyReach Anchor itself will be unfolded and
assembled on the ground and then lifted into place by a crane.
Please follow the instructions below.
This method only recommended when the distance between each
installed SkyReach Anchor is 8,5-11 m, when the 6,2 m Falcon fall
arrest block is used.
height.
SkyReach Anchor
31
Advertisement
Table of Contents
