Table of Contents
Advertisement
Assembly
2. The next step is to connect the fall arrest block. Make sure
that the component is correctly attached and secured to the
SkyReach Anchor. Figure 31 shows how the 6,2 m Falcon Fall
Arrest Block is attached to the anchor point.
Figure 31. Attaching a 6,2m Falcon Fall Arrest Block
NOTE
The SkyReach Anchor is equipped with two Endless Webbing
Slings which are used to lift the SkyReach Anchor by crane. Use
only the slings supplied by Combisafe. Use the slings only for
the purposes described in this user instruction. Please read the
Endless Webbing Sling User Instruction for more information.
3. Make sure that the Endless Webbing Slings are correctly
attached to the Lifting Eyes located at the brace and mast. It
is necessary to use both slings each connected to one lifting
eye. Attach the crane hook to both slings and lift the SkyReach
Anchor. Remove the plastic plug from the Cast-In Sleeve, then
lower the SkyReach Anchor down into the sleeve, see Figure 32.
If required, the SkyReach Reach Hook can be used to guide the
SkyReach Anchor into place by hooking to the mast and guide
the anchor into position.
SkyReach Anchor
33
Advertisement
Table of Contents
