Table of Contents
Advertisement
SkyReach Anchor
In this document two different methods to assemble and install
the SkyReach Anchor will be described. Either just by hand, or with
the help of a crane. The outcome of your risk analysis, depending
on the site, will decide what method to use.
Installation by hand
Due to the lightweight design of the SkyReach Anchor it can easily
be moved and installed by one person only. Follow the instructions
below to perform the installation in a safe and efficient way.
This method can only be recommended to use when the distance
between each installed SkyReach Anchor is 8,5 m or less, when
the 6,2 m Falcon fall arrest block and the 0,3 m extra webbing is
used.
1. Remove the plastic plug from the Cast-in Sleeve. Carry the
SkyReach Anchor in its folded position to its location at the
column. Use your shoulder for easier transfer, see Figure 25.
Lower the anchor and insert it into the sleeve. Make sure that
the SkyReach Anchor is fully inserted.
Figure 25. Moving the SkyReach Anchor by hand
28
Assembly
Assembly
Advertisement
Table of Contents
