Table of Contents
Advertisement
Beyond the basics
Continuous polling
To set up your machine for continuous polling:
1
Press
-
four times and then press
COM
OPTIONS
current time:
Cont Polling
Start Time:
2
Use the numeric keypad to enter the time your machine should begin the con-
tinuous polling. (Use the 24-hour format.) Here, we've set it for 7:00
Cont Polling
Start Time:
Note: Press
to move the cursor left, or /
3
When the start time is set, press
Cont Polling
End Time:
4
Use the numeric keypad to enter the time when your machine should finish
the continuous polling. (Use the 24-hour format.)Here, we've set it for 3:00
Cont Polling
End Time:
Note: If you set the end time earlier than the start time, the polling operation
will continue until the selected end time tomorrow.
Note: Press
to move the cursor left, or /
5
When the end time is set, press
Enter Fax Number
_
6
Enter the remote fax machine's number by either pressing a one-touch key,
entering a speed-dial number or using the numeric keypad.
If you are entering only one number for continuous polling, skip to step 8.
To add additional fax numbers for this operation, go on to step 7.
2.30
. The
shows the
ENTER
LCD
18:30
07:00
to move it right.
PROGRAM
to save it.The
shows:
ENTER
LCD
07:00
15:00
to move it right.
PROGRAM
to save it.The
shows:
ENTER
LCD
7
To add additional fax numbers, press
comma then enter the number as in step 6. You can specify up to 30 numbers
(and/or call groups) for continuous polling.
Press Start
[03],9-5551204,S118,
Important: Do not insert a comma after the last fax number.
Note: If you enter characters by mistake, press
.
AM
8
Press
START
When your machine polls for documents, it dials each number and, upon making
contact with the other machine, begins receiving the document as if the other
machine had placed the call. It will continue the process throughout the time period
you selected in steps 2–5.
Note: When you want to end a continuous polling operation, you must delete it
using the Review Commands feature (see page 2.18).
Being polled
Not only can you poll, but you can also be polled. To set up a document for regular
.
PM
polling:
1
If your fax machine is set for Tel Ready reception, press
change it to the Auto Answer mode. The Auto Answer light will glow.
Important: Your machine can't be polled if it's in Tel Ready mode.
2
Insert the document.
3
Adjust resolution and contrast if necessary. (Your fax machine will be trans-
mitting to the machine doing the polling.)
4
Press /
PROGRAM
Your fax will scan the document into memory and return to standby mode.
Note: If you want to return to the "Tel Ready" mode after the remote machine has
polled your document, press
control panel will turn off. But do this only after you're sure the remote
machine has polled your document.
Once the remote fax machine polls the document you stored, your fax machine auto-
matically erases the document from memory.
BROADCAST
.
,
, 1,
.
D
ENTER
. The Auto Answer light on the
AUTO ANSWER
between each one to insert a
to clear them.
CANCEL
to
AUTO ANSWER
Advertisement
Table of Contents
