Table of Contents
Advertisement
Selecting the compensation table, entering an axis correction
together
MOD
with
P00 CODE
DATUM (shown for approx. two seconds)
MOD
1)
SPACING
4 x
MOD
36
Select the operating parameters.
Select P00 CODE.
Enter the code number 10 52 96,
confirm with ENT.
1)
Enter the active datum for the error on
the axis to be corrected, e.g. 27 mm.
Press MOD to select the next input box.
Enter the spacing of the compensation
points on the axis to be corrected, for
m
10
example 2
m (equals 1.024 mm).
Press MOD four times to select COMP.
NR. 01. (You cannot enter values in the
POS. NR. 00, COMP. NR. 00 and POS.
NR. 01 boxes.)
COMP. NR. 01
Enter the associated compensation value,
e.g. 0.01 mm. Press MOD twice to
select COMP. NR. 02. (You cannot enter
2 x
MOD
any values in the POS. NR. 02 box).
COMP. NR. 02
Enter all further compensation points.
If you want so select a compensation
point directly, press CL and
2 x
MOD
simultaneously enter the desired
compensation point number.
Conclude entry.
1)
Only in the linear measurement mode
Advertisement
Table of Contents
