Linear/Angular Measuring Modes - HEIDENHAIN ND 281B User Manual

Linear/Angular Measuring Modes

You can select the linear measuring mode or angular
measuring mode by entering the code number 41 52 63:
➤ Select the user parameter P00 CODE
(see "Operating Parameters").
➤ Enter the code number 41 52 63.
➤ Confirm your entry with ENT.
➤ With the "." or "–" key, select the ND LENGTH or
ND ANGLE mode, respectively.
➤ Confirm your selection with ENT.
➤ The display unit resets itself.
➤ For further procedure, see "Switch-On, Traversing the
Reference Marks."
21