Table of Contents
Advertisement
Key
Function
• Set datum
• Transfer input value
• Set display to value from P79 (P80!)
• Leave parameter list
• Select datum
• Page backwards in parameter list
• Select parameter after switch-on
MOD
• Page forward in parameter list
• Start series of measurements
• Switch display for measurement series
• Start measured value output "PRINT"
• Delete entry
• Set display to zero (P80!)
• CL plus MOD: select parameter list
• CL plus number: select parameter
• Delete parameter input and show
parameter number
• Algebraic sign
• Reduce parameter value
• Decimal point
• Increase parameter value
1)
Only in linear measurement mode.
Indicator
REF
inch
1)
1 /
2
1)
PRINT
SET
< / = / >
MIN / MAX /
DIFF / ACTL
1)
START
Meaning
If the decimal point is also blinking:
Display is waiting for reference mark
traversing. If decimal point is not blinking:
Reference mark has been traversed—display
stores datum points in nonvolatile memory
Blinking: display is waiting for ENT or
CL to be depressed
Position values in inches
Selected datum point
"Linear measurement"
Blinking: Display is waiting for ENT to
be pressed for data output
"Angular measurement"
Measured value output with MOD key
Blinking: Display is waiting for input values
Sorting and tolerance checking:
measured value smaller than lower limit /
within the limits / greater than upper limit
Series of measurements: Minimum /
1)
maximum / greatest difference (MAX–MIN) /
current measured value
Blinking: Confirm selection or deselect
function
Series of measurements is running
Blinking: Display is waiting for signal to
start series of measurements
3
Advertisement
Table of Contents
