Table of Contents
Advertisement
Parameter
Settings/ Function
Display stop for measured value output
P23 DISPL.
Concurrent display, no display freeze;
the display value is the current actual
value
Frozen display; hold display until next
measured value output
Frozen/concurrent display; freeze display
as long as Pulse/Contact for measured
value output is present
Counting direction
P30 DIR
Positive counting direction with
positive direction of traverse DIRECT. POS
Negative counting direction with
positive direction of traverse DIRECT. NEG
Signal period
P31 S. PER.
0.000 000 01 < P31 < 99 999.9999
Default setting: 10 µm
Counting mode
P33 COUNT
0-1-2-3-4-5-6-7-8-9
0-2-4-6-8
0-5
Signal periods per revolution
P36 SP/R
1 < P36 < 999 999
Default setting: 36 000
DISPL. ACTL.
DISPL. HOLD
DISPL. STOP
1)
of encoder
1)
COUNT 0-1
COUNT 0-2
COUNT 0-5
2)
Parameter
Settings/ Function
Counting mode
P37 STEP
0-1-2-3-4-5-6-7-8-9
0-2-4-6-8
0-5
Decimal places
P38 DEC.
1 / 2 / 3 / 4 / 5 / 6
(up to 8 for inch display)
Select encoder compensation
P40 COMP.
No compensation
Multipoint: up to 64 compensation points for
linear encoders, up to 72 for angle encoders
(fixed spacing of 5 deg.)
Linear compensation
1)
Only in linear measurement mode.
2)
Only in angular measurement mode.
3)
Depends on signal period (P31) and unit of measure (P01)
2)
COUNT 0-1
COUNT 0-2
COUNT 0-5
3)
COMP. OFF
COMP. MULTI
1)
COMP. LIN
25
Advertisement
Table of Contents
