Table of Contents
Advertisement
Starting a series of measurements
Repeatedly
Select the display for a series of meas-
MOD
urements.
The selected indicator starts blinking
MAX
(here, MAX).
Confirm selection.
Repeatedly
... until the START indicator starts blinking.
MOD
START
Start the series of measurements.
Indicator preselection
Press MOD to start the series of measurements and select
the display with the indicators.
Operating parameter P86 allows you to define which indicator
is displayed first when MOD is pressed.
Switching between MIN, MAX, DIFF and ACTL displays
It is not possible to switch between the displays as
described below if the switching input for external
control of the series of measurements (pin 6 on
D-sub connection EXT) is active.
As an alternative, you can select the display with operating
parameter P21 (see "Operating Parameters").
Repeatedly
Select the new display of a series of
measurements.
MOD
The selected indicator starts blinking
MIN
(here, MIN).
Confirm the change.
The display now shows the smallest value measured during the
current series of measurements.
11
Advertisement
Table of Contents
