Remove Assembly; Remove The Supermodule From The Housing - Emerson Rosemount 3051S Manual

Wireless series scalable pressure, flow, and level solutions

Hide thumbs Also See for Rosemount 3051S:

Table of Contents

Rosemount 3051S Wireless Series

Remove Feature

Assembly

Figure 6-1. SuperModule

connector view

Remove the

SuperModule from the

Housing

6-4

The Wireless Feature Board is located in the electronics compartment. To

remove the assembly, perform the following procedure.

1. Remove the housing cover opposite the field terminal side.

2. Remove the LCD Display, if applicable. To do this, hold in the two clips

and pull outward.

3. Loosen the two small screws located on the assembly.

4. Replace the LCD Display. This will help in removing the assembly.

5. Pull out the assembly to expose and locate the SuperModule connector

and antenna connector.

6. Remove the LCD Display, if applicable. To do this, hold in the two clips

and pull outward.

7. Grasp antenna connector by the base and pull upwards to disconnect.

8. Grasp the SuperModule connector, squeeze the clips and pull upwards

(avoid pulling wires).

IMPORTANT

To prevent damage to the SuperModule cable, disconnect it from the

PlantWeb assembly before you remove the SuperModule from the housing.

Wireless PlantWeb Housing

Reference Manual

00809-0100-4802, Rev BA

August 2007

Table of Contents