Multitech MT5634HD16 User Manual page 60

MT5634HD8/16 User Guide
Command
Xn
\Xn
Yn
&Yn
Z
&Zn=x
,
;
!
$
54
Values Description
defaults.
n = 0–7 Result Codes and Call Progress Selection
X0 Basic result codes (CONNECT only); does not
look for dial tone or busy.
X1 Extended result codes (w/ CONNECT 1200,
CONNECT 2400, etc.); does not look for dial
tone or busy signal.
X2 Extended result codes with NO DIAL TONE;
does not look for busy signal.
X3 Extended result codes with BUSY; does not look
for dial tone.
*** X4 Extended result codes with NO DIAL TONE
and BUSY.
X5 Extended result codes with NO DIAL TONE
and BUSY.
X6 Extended result codes with NO DIAL TONE
and BUSY.
X7 Basic result codes with NO DIAL TONE and
BUSY.
n = 0 XON/XOFF Pass-Through
*** \X0 Respond to and discard XON\XOFF characters.
n = 0 Long Space Disconnect
*** Y0 Disable sending or responding to long space
break signal on disconnect.
n = 0 Select Stored Configuration for Hard Reset
*** &Y0 Select stored configuration 0 at power-up
(included for backward compatibility with some
software.)
n/a Modem Reset
Reset modem to default values. Defaults come from
NVRAM if &W0 is set, from ROM if &W1 is set.
n = 0-3, x = Store Telephone Number
dialing string. Stores telephone dial string x in memory location n.
Dial the stored number using the command ATDS=n.
In dial Dialing Pause
command Comma; causes dialing pause for time set by S8.
At end of dial Return to Command Mode After Dialing
command Semi-colon; causes immediate return to command
mode after dialing.
In dial Flash On-Hook
command Exclamation; causes modem to flash on-hook.
In dial Detect Call Card
command Causes the modem to pause and wait for an AT&T
call card "bong" or a 1600 Hz tone before processing
CommPlete Communications Server