Multitech MT5634HD16 User Manual page 56

MT5634HD8/16 User Guide
Command
Ds
&Dn
DSn
En
+ES=6
Fn
&Fn
&Gn
\Gn
50
Values Description
s = phone # Dial
Dial telephone number s, where s may include up to
40 alpha-numeric characters, and the L, P, T, V, W,
comma (,), colon (:), semicolon (;), !, $, @ and ^ dial
string modifiers.
n = 0, 1, 2, Data Terminal Ready Control
or 3 &D0 Modem ignores DTR signal.
&D1 When DTR drops while in online data mode, the
modem enters command mode, issues an OK,
and remains connected.
*** &D2 When DTR drops while in online data mode, the
modem hangs up.
&D3 When DTR drops, the modem hangs up and
resets as if the ATZ command had been
issued.
n = 0, 1, 2, Dial Stored Telephone Number
or 3 Dial a number previous stored in directory number n
by the &Zn=x command. For example, ATDS3.
n = 0 or 1 Echo Command Mode Characters
E0 Do not echo command mode characters.
*** E1 Echo command mode characters.
n/a Enable Synchronous Buffered Mode
Allows an H.324 video application direct access to the
synchronous data channel. On underflow, the modem
sends the HDLC flag idle (0x7E) to the remote
modem. This special error correction mode is
overridden by any of the following commands: &F,
&M, &Q, and \N. +ES=? Shows the only allowed
value.
n = 1 Echo Online Data Characters
*** F1 Disable online data character echo (included for
backward compatibility with some software.
n = 0 Load Default Configuration
*** &F0 Load factory default values as active
configuration.
n = 0, 1, or 2 Guard Tones (International model only)
*** &G0 Turn off ITU-T guard tones.
&G1 Turn on ITU-T 550 Hz guard tone.
&G2 Turn on ITU-T 1800 Hz guard tone.
Note: The U.K. model is locked to &G2, which turns
on the ITU-T 1800 Hz guard tone.
n = 0 Modem Port Flow Control
*** \G0 Returns an OK for backward compatibility with
some software.
CommPlete Communications Server